1951 Chevy Accessories Installation Manual

ALARM. 4. Cut mat if necessary for clearance of spring.
Approximate Flat Rate Time .2 of an hour. 986442 WIRING JUNCTION BLOCK
Procedure for Installing Wiring Junction Block on All Model Passenger Cars.
1.    Remove inspection hole cover on dash.
2.    Install Junction Block to dash inspection hole flange (Using the existing holes in flange) with screws, nuts and lockwashers furnished. (See figure 3.)
3.    Route Junction Block wiring harness as shown in figure 5, attaching to the main wiring harness with the wire clamps fur­nished, and connect as follows:
tmpB3-1.jpg
Figure 3
tmpB3-2.jpg
Figure 4