1951 Chevy Accessories Installation Manual

Figure 145
2.    Install rear view mirror clamp assembly with screw previously removed from mirror assembly, (see figure 145).
3.    With pad in place under base of mirror, in­stall mirror on top of door with center of base located above rear edge of division channel, (see figure 145), and insert clamp between rubber door seal. Tighten set, screws.
4.    Adjust angle of mirror to suit.
5.    If additional adjustment is desired remove mirror from door and adjust clamp on mir­ror arm by loosening screw and rotating to desired position.
Figure 146
1.    Place the two clips on the mirror over the right-hand sun visor and center mirror on visor as shown in figure 147.
2.    Wrap wire around visor arm and bracket, allowing sufficient wire to permit visor ad­justment as shown in figure 147.
3.    Pin wire to pillar trim, using the three pins provided.
Approximate Flat Rate Time .2 of an hour.
Procedure for Installation of Vanity Visor Mirror on All Model Passenger Cars.