|
1951 Chevy Accessories Installation Manual |
|||
|
plate in exact location on door
and hold in |
|||
|
|
|||
 |
 |
||
|
Figure 165
place with
short strips of tape (see figure 165).
2. Center punch two location holes and drill
with a No. 29 or 9/64" drill.
DO NOT TAP HOLES.
3. Leaving the paper Template on
door (see figure 165), place
Bracket and Gasket over 9/64"
holes so that Bracket hub extends forward, then fasten Bracket securely in
place with oval head sheet
metal screws. Care should be
taken to tighten each screw only a little at a time, until both screws
are tight, to keep the Bracket
from creeping.
4. Drill through door with 1/2" drill,
preferably of the hole saw type, using the mounting bracket as a drill jig. (See figure
166.) HOLD DRILL IN LINE WITH
BRACKET. FEED DRILL
SLOWLY. |
|||
|
Figure 163
NOTE: Do
not use a heavy hammer blow as it will
dent the wheel ring. A light tap with the hammer and wood block is sufficient
as shown in figure
163.
Approximate Flat Rate Time .1 of an hour. 986407 SAFETYLIGHT AND MIRROR UNIT Procedure
for Installation of
Safetylight and Mirror
on All Model Passenger
Cars. |
|||
 |
|||
 |
|||
|
Figure
164 Drilling The Door |
|||
|
1. Select the proper Mounting
Template and cut out along heavy black lines. Place
Tern- |
|||
|
Figure
166 |
|||
|
|
|||
|
67 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|