1951 Chevy Accessories Installation Manual
Replace seat back panel and metal screws
Remove seat adjuster knob and side panels
from seat assembly.
Remove four cap screws from each side of
seat assembly which holds seat to floor pan
of body and remove seat assembly from car.
Remove two sheet metal screws located at bottom rear edge of back rest and hairpin
clip from back rest shaft on outside end of
and replace seat assembly in car and tighten
8. Replace side panels and seat adjuster knob.
Approximate Flat Rate Time 1.5 hours.
ALL TWO-DOOR FRONT SEATS
Two-Door Sedans, Bel Airs and Convertibles
(Fiber - Plastic - Rayon)
« PREVIOUS PAGE
NEXT PAGE »