EH Holden

EH Identification Plates

From a set of numbers we can establish some of the history of your EJ or EH. It is all relative to the amount of info you have. I will go through examples and explain what they mean. First of all I will start with the chassis number it is NOT the little tag below the BODY ID tag. It is found stamped in the engine bay skirt panel on the drivers side. A typical example would be 'EH12345M'. The first two letters will state simply whether the vehicle is an 'EJ' or 'EH' .The numbers that follow indicate the number for that vehicle off the line at the plant it was built and/or assembled at. The chassis numbers started at 1001. This brings us to the final letter, which will be either
A
- Adelaide
B - Brisbane (assembly only)
M - Melbourne
S - Sydney
P - Perth (assembly only)
NZ - New Zealand (assembly only)

The codes as shown on a sample Body Identification plate below are explained as follows. The small plate with a number on it below the main Body ID plate is a stock number.

The BODY code on this plate holds most of the information. A typical example would be 'EH 225A-1001M' and can be broken up as follows.The first two letters will state simply whether the vehicle is an 'EJ' or 'EH' The next group of three or four numbers will indicate the body style

215
Standard Sedan
219 Standard Station Sedan
225 Special Sedan
229 Special Station Sedan
235 Premier Sedan
239 Premier Station Sedan
2104 Panel Van
2106 Coupe-Utility

The 'M' or 'A' that follows indicates Manual or Automatic

The next group of 1-5 numbers is the number of that vehicle bodystyle off the line at the plant (including assembly) concerned in the last letter.The last letter indicates the plant that the body shell was built at. Bodyshells were built at these three plants only. Final assembly was done at a number of plants. This number starts at 1.
A
- Adelaide
M - Melbourne
S - Sydney

What about S4?

There were quite a number of special build codes and from time to time they are seen to be stamped for obvious reasons. S4 is definitley stamped on the S4 model EH's, but has been seen stamped on other seemingly standard models as well. Other codes like s7, s9, s12 also pop up from time to time. It seems a couple of ex-railways panelvans have had S12, but what difference this means in actual build of the vehicle we are still not sure.

The Trim code is in two parts and the first part which is 3 or four digits indicates the paint scheme used. The second part starting with 'B' or 'C' followed by two digits indicates the interior trim itself.

   

Contents

Holden Cars
Falcon Cars
Valiant Cars
Buick Cars & Trucks
Chevrolet Cars & Trucks
Chrysler Cars & Trucks
Dodge Cars & Trucks
Ford Cars & Trucks
GMC Cars & Trucks
International Cars & Trucks
Oldsmobile Cars & Trucks
Plymouth Cars & Trucks
Pontiac Cars & Trucks
Studebaker Cars & Trucks
Willys Cars & Trucks

Other HRDU Sites

Hot Rod Events
Hot Rod History
Hot Rod Hall of Fame
Hot Rod Magazines
Hot Rod Books
Hot Rod Tech
Hot Rod Tours
Kustoms
Memorabilia
Show Rods
Land Speed Australia
Land Speed America
LSR History
LSR Historians

More HRDU Sites

All About 1934 Chev's
48-53 Chev Pickup's
History of the Corvette
Prototypes
Car Spotters Guide
Monaro Shrine
Aussie Utes
Wheelstanders
Scallops
Slopers

About

About Hot Rods Down Under
Contact Us
Copyright
Disclaimer
Terms and Conditions
Privacy
Site Map

Hot Rods Down Under
Movies
Music
TV
Calendar
Links
Home