What’s a prototype?
1951 How it all began
1952 Corvette EX-122
1954 Corvette Corvair Motorama showcar
1954 Corvette Hardtop Motorama Showcar
1954 Corvette Nomad Motorama Showcar
1955 Corvette Biscayne Show Car
1956 Harlow Curtis SR-2 Lookalike
1956 Corvette Impala Show Car
1956 Corvette SR-2 Sebring Racer
1952 EX-122 Concept Car
1957 Q Corvette
1957 Corvette SS Show Car
1957 Corvette SS XP-64
1958 XP-700
1959 Stingray Racer XP-87
1959 Corvette Stingray
1961 Corvette Mako Shark XP-755
1962 C2 Prototype XP-720
1962 Four Seat Stingray Corvette XP-720 2+2
1963 Corvette Rondine Pininfarina Coupe
1963 Corvette Grand Sport
1963 Wedge Corvette Split Windshield
1964 World’s Fair Styling Study
1964 Clay model for '66 update
1964 Grand Sport GS-II(b)
1964 CERV II
1964 Pontiac Banshee XP-833
1964 Corvette XP-819 Rear Engine
1965 Corvette Mako Shark XP-830
1966 Mid Engine Styling Proposal
1967 Astro I
1968 Corvette Astro-Vette
1968 Astro II-XP-880 mid engine
1969 Astro III
1969 Manta Ray
1969 Mid Engine XP-882
1970 Scirocco Showcar
1970 Corvette XP-882
1973 Corvette 2 rotor XP-897-GT
1973 Reynolds XP-895
1973 Corvette 4 rotor XP-882
1973 Corvette XP-898
1974 Mulsanne Showcar
1976 Corvette XP-882
1979 Turbo Corvette
1978 Corvette Astro-Vette
1980 Turbo Corvette
1982 4th Generation Concepts
1984 Bertone Ramarro
1985 Corvette Indy
1986 GTP Corvette
1987 Corvette Geneve
1989 Corvette DR-1
1989 Corvette ZR-2
1990 Corvette Conan ZR-12 V12
1990 Bertone Nivola
1991 ZR-1 Snake Skinner
1992 Stingray III
2001 Corvette Tiger Shark
2003 Corvette Italdesign Moray
2009 Sideswipe

1968 Chevrolet Astro II XP-880

1968 Chevrolet Astro II XP-880

Almost from the beginning, racing has made the Corvette a living legend. Sports car development in the 1960s was explosive, and at the cutting edge was the Ford GT40 and the Chevrolet-backed Chaparral, both using a mid-engine layout. The Astro II (XP-880) was the first of several experimental, mid-engine Corvettes that kicked off years of exotic sports car anticipation.

The Astro II, revealed at the 1968 New York Auto Show, was less extreme in its styling than Astro I. It was designed primarily to showcase its rear-mounted powertrain application. Unlike the Astro I, Astro II had doors to access the passenger compartment. The rear compartment hatch still lifted up – this time, to provide access to the engine compartment. The front compartment was designed as a storage area. Chevy R&D's first mid-engine Corvette positioned a big-block V-8 backwards so the starter and ring gear nestled under the reclined seats and the tall accessory drive rode in back. The Tempest transaxle's torque converter bolted to what's usually the front of the crankshaft. The finished car weighed 200 pounds less than a stock 427 Corvette, but the transaxle was far too weak.

Ford started the race by first offering a street version of their GT40, called "Mark III" and then by unveiling the "Mach 2" experimental mid-engine car in May 1967. Designers at Chevrolet went right to work on their own version of a mid-engine Corvette. After 11 months, the Astro II was shown, immediately initiating a blizzard of speculation asking the question, "Is this the next Vette?"

By using off-the-shelf parts, the designers were able to deliver the car quickly, and at a relatively low cost. However, because of a lack of serious commitment by Chevrolet, the car was made using an out of production, '63 Pontiac Tempest, two-speed transaxle. Ford, on the other hand, had a race-proven, four-speed manual gear box for the Mach 2. The big question was, if pushed into production, would a two-speed automatic Corvette be taken seriously. Probably not.

Despite its built-in design weakness, the Astro II was a very interesting effort. It certainly looked exotic and screamed "Corvette" with its body styling. The Astro II used a central backbone frame and thick doors that housed safety beams. The 20-gallon fuel cell was located in the center of the frame. The engine, suspension and drivetrain were all attached to the central frame. With a 427 engine, this made the car more like a Can-Am racer than a street car. Even with production Camaro and Corvette suspension parts, and performance street tires, the Astro II generated 1.0 g of cornering grip. This was part of the magic of a mid-engine sports car. Astro II weighed in at 3,300 pounds, 300 less than a production Corvette, yet had almost the same external dimensions.

While the Astro II was being track tested in Spring 1968, Duntov and his crew were busy working on their solution to the transaxle problem, the stunning XP-882. This one almost made it to the showroom. The Astro II XP-880 made its debut at the 1968 New York Auto Show. Its predecessor, Astro 1, was an extreme design; it did not have conventional doors and was powered by an air-cooled engine. The Astro II was not called a Corvette but it featured a standard Corvette angine and conventional doors. The mid-engine powertrain design was, however, radically different from the standard Corvette chassis. The entire rear half of the car's fiberglass body is hinged to tilt up for engine access. Almost forty years later, it remains a stunning example of automotive design.

Home | Hot Rod | Movies | Music | TV | Calendar | Links
© 2009 High Performance Web Sites. All Rights Reserved